Cy Kick CS

What is the required application rate for Rabbitbrush when treating Big Sagebrush and Rabbitbrush?

• 2-1/4 pints per acre
• 3 quarts per acre
• 6-3/4 pints per acre ✓
• 4 pints per acre

Answer: For Big Sagebrush and Rabbitbrush, the label states the 6-3/4 pints rate is usually required for rabbitbrush.

🔗 Source

For Tree Injections (Pine Release) targeting hardwoods like Oak, Hickory, or Maple, what is the recommended spacing for injections?

• 1 to 1-1/2 inches apart edge to edge
• 2 inches apart edge to edge ✓
• 5 inches apart edge to edge
• Injections should be made once per tree

Answer: For hardwoods in tree injections, the label instructs to space injections 2 inches apart edge to edge.

🔗 Source

When applying to Northern conifers, Jack Pine, Red Pine, Black Spruce, and White Spruce to control hardwoods, when should the application occur?

• In the spring during flower head emergence
• After the conifers cease growth and 'harden off' (usually mid-July) ✓
• Between May 15 and June 15
• While pine buds are still dormant

Answer: The label states to apply by air after these specific conifers cease growth and 'harden off', usually in mid-July.

🔗 Source

To release Douglas fir, hemlock, Sitka spruce or grand fir, what is the correct application rate and timing?

• 3 quarts per acre before new growth on Douglas fir is 2 inches long ✓
• 1-1/2 to 2 quarts per acre when 3/4 of foliage has full size leaves
• 2 quarts per acre while pine buds are still dormant
• 3 quarts per acre before pine growth begins in the Spring

Answer: The label states to apply 3 quarts of product per acre before new growth on Douglas fir is 2 inches long to release these species.

🔗 Source

When performing a 'Dormant Application (other than pine)' for susceptible deciduous brush species, what should be used as the carrier/dilution?

• 8 to 25 gallons of water per acre
• Sufficient diesel, fuel oil or kerosene per acre ✓
• Undiluted product
• 100 gallons of water per acre

Answer: For dormant applications of susceptible deciduous brush species, the label specifies using sufficient diesel, fuel oil or kerosene per acre.

🔗 Source

According to the label, what is a major restriction when applying Cy Kick CS to Pine?

• Do not apply by aircraft
• Do not use unless some pine injury is acceptable ✓
• Do not apply during the growing season
• Do not use with water as a carrier

Answer: The label explicitly states: 'Do not use this application unless some pine injury is acceptable.'

🔗 Source

When targeting Sand Shinnery Oak via aircraft application, what is the required timing window?

• Between May 15 and June 15 ✓
• Between early May and mid-June
• During the spring flower head emergence
• Between May 15 and October 15

Answer: The label specifies that Sand Shinnery Oak should be applied by aircraft between May 15 and June 15.

🔗 Source

When treating Cattails, Tule (Bulrush), and other rushes, what is the specified dilution for the 4 pint application rate?

• 5 gallons of water per acre
• 3 gallons of water per acre
• 100 gallons of water ✓
• 8 to 25 gallons of water per acre

Answer: For Cattails, Tule, and other rushes, the mixing section specifies 4 pints per 100 gallons of water.

🔗 Source